Quality Kennesaw GA septic system installers do a great deal of legwork, long before a unit gets installed into the ground. A brand new unit will last years, and possibly even generations, if it’s set up properly, but it can fall short instantly if it’s not. On top of that, all Kennesaw GA septic system installers must secure a permit in order to execute the install, and may have to work with city or county officials to show that particular tests were done in order to continue. These three tests are essential primary steps that should always be taken before any job or designs are done, and it may also be helpful to perform them before you purchase a property, so you could be assured that a tank and leach field will be allowed.
1. Pit
The pit test is very direct. During the course of this test, a hole is dug and the soil is examined to determine its structure. A typical leach field is dependent on the soil’s composition to drain effectively. If there is a lot of gravel or sand, your leach field should be ready to discharge the effluent (water) from the tank well, where the soil will finish sanitizing it. If the soil has a considerable amount of clay or rock, it won’t drain well, consequently a standard leach field will not be an option. If the site you’ve picked does not successfully pass the pit test, you may be able to choose another site on your house or use an alternate kind of drain field, such as a mound system.
2. Perc
The perc, or percolation test, calls for digging a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then saturating it with water. The hole is normally left saturated for about two hours, and refilled as needed. After this, the hole is filled with 6 inches of water and observed for water drainage.
3. Visual
There are many things an inspector will check visually. A lot of units are gravity-fed, so they don’t depend on electricity or pumps to transfer effluent from the tank to the leach field. Because of this, the incline of the ground is very important. An inspector will also seek out slopes that could feed excessive water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Work with Quality Kennesaw GA Septic System Installers Today
Picking the right configuration, type of system, and assessing the land properly, are all fundamental steps in making sure an install goes off without a hitch. Most importantly, these steps guarantee that the install is done correctly, so that a system provides decades of use without problems. If you’re prepping for an install, call Atlanta Septic Tank Pros. Our technicians are skilled and devoted to quality, so you could be sure the job is done right. Call (404) 998-8812 today.