Quality Clarkston GA septic system installers do a lot of legwork, long before a unit gets placed into the ground. A brand new unit will last many years, and possibly even generations, if it’s placed correctly, but it can fall short immediately if it’s not. Additionally, all Clarkston GA septic system installers must acquire a permit in order to execute the install, and may need to work with city or county officials to show that certain tests were run in order to proceed. These three tests are necessary initial steps that should always be taken before any task or designs are done, and it may also be helpful to do them before you purchase a property, so you can be assured that a tank and leach field will be allowed.
1. Pit
The pit test is pretty straightforward. In the course of this test, a hole is dug and the soil is analyzed to establish its composition. A conventional leach field is dependent on the soil’s composition to drain efficiently. If there is a considerable amount of gravel or sand, your leach field should be ready to discharge the effluent (water) from the tank well, where the soil will finish cleaning it. If the soil has a bunch of clay or rock, it won’t sink well, consequently a standard leach field will not be an option. If the location you’ve chosen does not pass the pit test, you may be able to select another site on your home or use an alternate kind of drain field, such as a mound system.
2. Perc
The perc, or percolation test, involves digging a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then filling it with water. The hole is typically left drenched for about two hours, and refilled as needed. Then, the hole is filled with 6 inches of water and monitored for drainage.
3. Visual
There are several things an inspector will look into visually. Most units are gravity-fed, so they don’t depend on electricity or pumps to move effluent from the tank to the leach field. Because of this, the incline of the ground is important. An inspector will also look for inclines that can feed excess water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Enlist the Services of Quality Clarkston GA Septic System Installers Today
Choosing the right configuration, type of system, and evaluating the land effectively, are all important steps in making sure an install goes off without a hitch. Most significantly, these steps guarantee that the install is done properly, so that a system provides years of use without issue. If you’re preparing for an install, contact Atlanta Septic Tank Pros. Our professionals are skilled and committed to quality, so you could be sure the job is done right. Call (404) 998-8812 now.