
Quality Conley GA septic system installers do a number of examination, long before a unit gets placed into the ground. A new unit will last many years, and possibly even generations, if it’s set up properly, but it can fall short instantaneously if it’s not. Furthermore, all Conley GA septic system installers must secure a permit in order to carry out the install, and may will have to work with city or county officials to show that a number of tests were performed in order to continue. These three evaluations are vital initial steps that should always be taken before any job or designs are done, and it may also be beneficial to perform them before you buy a property, so you could be assured that a tank and leach field will be permitted.
1. Pit
The pit test is quite straightforward. During this test, a hole is dug down and the soil is examined to determine its structure. A conventional leach field is reliant on the soil’s composition to drain successfully. If there is a lot of gravel or sand, your leach field should be able to discharge the effluent (water) from the tank well, where the soil will finish sanitizing it. If the soil has a lot of clay or rock, it won’t sink well, and so a conventional leach field will not be an alternative. If the site you’ve selected does not pass the pit test, you may be able to pick another site on your house or use an alternate kind of drain field, such as a mound system.
2. Perc
The perc, or percolation test, consists of digging a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then filling it with water. The hole is typically left soaked for about two hours, and topped off as needed. After this, the hole is filled with 6 inches of water and observed for water drainage.
3. Visual
There are many things an inspector will investigate visually. Most units are gravity-fed, so they don’t rely upon electricity or pumps to shift effluent from the tank to the leach field. Because of this, the incline of the ground is important. An inspector will also try to find inclines that could feed excess water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Enlist the Services of Quality Conley GA Septic System Installers Now
Picking the right configuration, kind of system, and assessing the land effectively, are all essential procedures in making sure an install goes off without a hitch. Most importantly, these steps guarantee that the install is done properly, so that a system provides years of use without problems. If you’re prepping for an install, call Atlanta Septic Tank Pros. Our specialists are experienced and committed to quality, so you can be sure the job is done right. Call (404) 998-8812 now.